Altronix EFLOW102NA8D 8 PTC Class 2 Relay Outputs Access Power Controller with Power Supply/Charger, BC400 Enclosure

Altronix EFLOW102NA8D Access Power Controller Features

The eFlow102NA8D distributes and switches power to access control systems and accessories. It converts a 120VAC 60Hz input into eight (8) independently controlled 12VDC PTC protected outputs. These power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. Unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.

Features

• Input: 120VAC 60Hz, 3.5 amp
• Output: 12VDC outputs @ 10 amp supply current
• Protection: Power-limited outputs
• Control: Eight (8) independently trigger controlled outputs
• AC Fail Supervision: AC fail supervision (form "C" contacts)
• Battery Supervision: Battery fail & presence supervision (form "C" contacts)
• Low Power Shutdown: Shuts down DC output terminals if battery voltage drops below 71-73% (depending on the power supply)
• Discharge Prevention: Prevents deep battery discharge
• Indicators: AC input and DC output LED indicators
• Charger: Built-in charger for sealed lead acid or gel type batteries
• Maximum Charge Current: Power Supply Board maximum charge current 1.54 amp
• Backup Power: Automatic switch over to stand-by battery when AC fails. Transfer to stand-by battery power is instantaneous with no interruption
• Zero Voltage Drop: Zero voltage drop when unit switches over to battery backup (AC failure condition)

Altronix EFLOW102NA8D Detailed Specifications