Pelco FT82041MSTR-1 Multi-Mode-Eth Fiber SW 4 Base, TX, ST

Ethernet Fiber Switch, four 10BASE-T/100BASE-T Ports and one 100BASE-FX Fiber Port, 1 fiber, single-width module, MULTI-MODE, ST Connector, Transmitter

The FT82041/FR82041 unmanaged Ethernet switch provides four 10BASE-T/100BASE-TX ports and one 100BASE-FX port for the transport of bidirectional Ethernet data. Designed for point-to-point applications, the FT82041 and FR82041 switches are used in combination with one another to provide wavelength compatibility. Using wavelength division multiplexing (WDM), bidirectional data is transported in one multimode or single-mode fiber.

Features

• Unmanaged Ethernet Switch for the Transport of Bidirectional Ethernet Data:

• Four 10BASE-T/100BASE-TX Ports

• One 100BASE-FX Port

• Integrated Wavelength Division Multiplexing (WDM) in a Single Fiber

• Designed for Point-to-Point Applications

• User-Selectable Networking Functions for Each 10BASE-T/ 100BASE-TX Port:

• Autonegotiation Between 10 Mbps and 100 Mbps Data Rates and Between Full-Duplex and Half-Duplex Modes

• 10 Mbps or 100 Mbps Selectable

• Full-Duplex or Half-Duplex Mode Selectable

• Enabling/Disabling of Flow Control

• Auto MDI/MDI-X (Medium Dependent Interface/Medium Dependent Interface Crossover) Operation

• Compliant with IEEE 802.3, 802.3u, and 802.3x Standards

• Multimode Fiber Support for Distances up to 2 km

• Single-Mode Fiber Support for Distances up to 46 km

• Laser Diode for Transmission of Optical Signals

• Environmentally Hardened

• Designed to Meet NEMA TS 2 and Caltrans Traffic Signal Control Equipment Environmental Standards

• No Performance Adjustments Required

• 12 VDC or 24 VAC Power Supply

• Stand-Alone and Rack-Mountable Modular Design

• LED Indicators for Monitoring of Optic Signal/Laser Status, 100BASE-FX Port Status Including Far End Fault

• Indication (FEFI), 10BASE-T/100BASE-TX Port Status, and Operating Power