- Complete Systems
-
Security Cameras
-
Recording
- Monitors
- Network
- Transmission
- Security
- Audio
- Accessories
- Power
- Complete Systems
-
Security Cameras
-
Recording
- Monitors
- Network
- Transmission
- Security
- Audio
- Accessories
- Power
- Home
- NVT Power , Video, Datas
Product was successfully added to your shopping cart.- Power-Video (PV) signals are routed via UTP and RJ45
- Use with NVT’s PVDTM
- Power Supply Hubs and Cable Integrators, or with a second NV-216A-PV
- Frequency response DC to 10MHz (see Resolution Distance Chart)
- Exceptional interference rejection
Availability: Usually ships the next business day- Transmits 10/100 BaseT Full Duplex Ethernet up to 1,000' (305m) over 4-pair cat5; 750' (228m) over 18/2 (or similar 2-wire cable); 500' (150m) over shielded twisted-pair 1
- 48 or 56VDC is distributed over 2-wire cable to all connected IP devices
- Powers PoE entry stations (or other PoE or PoE+ devices), up to 60W 2
- One NVT Eo2 transceiver at the network-end can support multiple remote Eo2 transceivers and connected devices 3
- Up to 4 Eo2 transceivers can be rack mounted on an NV-RMEC16U Eo2 Rack Mount Tray Kit, connecting up to 16 entry stations or other devices
Availability: Usually ships the next business day- Extended distance camera power and video routed through UTP and RJ45
- Supports 12VDC cameras with onboard regulated power
- Use with NVT's PVD(tm) Power Supply Hubs and Cable Integrators
- Up to 3000ft (1km) with a NVT DigitalEQ(tm) Active Receiver (see Power Distance Calculator)
- Up to 1500ft (460m) with a NVT StubEQ(tm) Hub (see Power Distance Calculator)
Availability: Usually ships the next business day- Transmits power, video and Data (PVD) over a single UTP cable
- Up to 3000' (1km) when used with an active receiver or hub
- Supports Coaxitron (up the coax) control up to 750' (225 m)
- BNC port with 9" pigtail cable for in-camera mounting in most dome cameras
- Compatible with NV-704J-PVD and NV-716J-PVD for better cable management with IDF
Availability: Usually ships the next business day- 100 BaseT transmission; Network speeds up to 93 Mbps; Up to 1,000ft (305m)
- One NV-EC1701U transceiver at the network-end can support multiple remote transceivers/IP cameras
- 56 VDC is distributed over the coax to all connected equipment
- Powers PoE, PoE+, or High Power PoE cameras (or other PoE devices), up to 50 watts
- Easy configuration, no PC required
Availability: Usually ships within 2-3 business days- 56 VDC is distributed over the coax to all connected equipment
- Easy configuration, no PC required
- Transparently supports all networking protocols (UDP, TCP/IP, HTTP, Multicast, etc.)
- 128-bit AES encrypted transmission
- Built-in transient protection; Industrial temperature range
Availability: Usually ships the next business day- 56 VDC is distributed over the coax to all connected equipment
- Easy configuration, no PC required
- Transparently supports all networking protocols (UDP, TCP/IP, HTTP, Multicast, etc.)
- 128-bit AES encrypted transmission
- Built-in transient protection; Industrial temperature range
Availability: Usually ships the next business day- 56 VDC is distributed over the coax to all connected equipment
- Easy configuration, no PC required
- Transparently supports all networking protocols (UDP, TCP/IP, HTTP, Multicast, etc.)
- 128-bit AES encrypted transmission
- Built-in transient protection; Industrial temperature range
Availability: Usually ships the next business day- Connectivity for up to four cameras, each via a single RJ45 4-pair cable
- Use with the NV-216A-PV or NV-218A-PVD transceivers or the NV-226J-PV transmitter at the camera
- Uses any third-party power supply to power cameras via UTP over significant distances (see Power Distance Calculator)
- Cable-management solution from the camera to the Wiring Closet and on to the Control Room
- Wall-mountable; rack-mountable using the NV-RM8/10 panel
Availability: Usually ships the next business day- Connectivity for up to sixteen cameras, each via a single RJ45 4-pair cable
- Use with the NV-216A-PV or NV-218A-PVD transceivers or the NV-226J-PV transmitter at the camera
- Uses any third-party power supply to power cameras via UTP over significant distances (see Power Distance Calculator)
- Cable-management solution from the camera to the Wiring Closet and on to the Control Room
- 1U high; 1" deep; wall or rack-mountable
Availability: Usually ships the next business day- Provides Class 2 SELV 28 VAC with up to 1 Amp/channel while receiving video transmission and delivering P/T/Z telemetry, all over a single 4-pair Cat5 cable for each camera
- Built-in distribution amplifier with 2 video outputs per channel
- Full motion CCTV video at distances up to 1,500ft (460m) when used with any passive NVT transceiver
- Adaptive StubEQTM fully automatic 2-band equalization provides adjustment free equalization every time, no manual adjustments required
- Automatic-reset fault protection; transient protection
Availability: Usually ships the next business day- Provides Class 2 SELV camera power and pass-through video and telemetry data connectivity for up to 4 cameras, each via a single RJ45 4-pair UTP cable
- Standard telecom/datacom structured cabling pinouts per EIA/TIA 568B
- Independently selectable 24 or 28VAC with 1 Amp max per channel
- Automatic-reset fault protection; transient protection
- Individually floating outputs ensure total ground-loop immunity
Availability: Usually ships the next business day- Provides Class 2 SELV 28 VAC with up to 1 Amp/channel while receiving video transmission and delivering P/T/Z telemetry, all over a single 4-pair Cat5 cable for each camera
- Built-in distribution amplifier with 2 video outputs per channel
- Full motion CCTV video at distances up to 1,500ft (460m) when used with any passive NVT transceiver
- Adaptive StubEQ fully automatic 2-band equalization provides adjustment free equalization every time, no manual adjustments required
- Automatic-reset fault protection; transient protection
Availability: Usually ships the next business day- Standard telecom/datacom structured cabling pinouts per EIA/TIA 568B
- Independently selectable 24VAC-OFF-28VAC with 1 Amp per channel
- Automatic-reset fault protection; transient protection
- Individually floating outputs ensure total ground-loop immunity
- Diagnostic LEDs show load/no load, miswires, and overload conditions
Availability: Usually ships the next business day- 100 BaseT transmission; Network speeds up to 93 Mbps; Up to 1,000ft (305m)
- One NV-EC1701U transceiver at the network-end can support multiple remote transceivers/IP cameras
- 56 VDC is distributed over the coax to all connected equipment
- Powers PoE, PoE+, or High Power PoE cameras (or other PoE devices), up to 50 watts
- Easy configuration, no PC required
Availability: Usually ships the next business day- Provides Class 2 SELV 28 VAC with up to 0.5 Amp/channel while receiving video transmission and delivering P/T/Z telemetry, all over a single 4-pair Cat5 cable for each camera
- Features 32-Channels with one video output per channel
- Full motion CCTV video at distances up to 1,500ft (460m) when used with any passive NVT transceiver
- Adaptive StubEQ fully automatic 2-band equalization provides adjustment free equalization every time, no manual adjustments required
- Automatic-reset fault protection; transient protection
Availability: Usually ships the next business day- Provides Class 2 SELV camera power while receiving video transmission and delivering P/T/Z telemetry all over a single 4-pair Cat5e cable
- Standard telecom/datacom structured cabling pinouts per EIA/TIA 568B
- Independently selectable 24VAC-OFF-28VAC with 1 Amp per channel
- Automatic-reset fault protection; transient protection
- Individually floating outputs ensure total ground-loop immunity
Availability: Usually ships the next business day- Provides Class 2 SELV camera power while receiving video transmission and delivering P/T/Z telemetry all over a single 4-pair Cat5e cable
- Standard telecom/datacom structured cabling pinouts per EIA/TIA 568B
- Independently selectable 24VAC-OFF-28VAC with 1 Amp per channel
- Automatic-reset fault protection; transient protection
- Individually floating outputs ensure total ground-loop immunity
Availability: Usually ships the next business day- 1
- 2
NVT Power , Video, Datas- Categories
- Price
-
$52$3999Price Up to $3999
-
- Manufacturer
- NVT (22)
- Channels
- Connection Type
- BNC (14)
- RJ-45 (17)
- Screw Terminals (6)
- Form
- Rack Mount (7)
- Stand-Alone (15)
- Integral Camera Power
- With Power (19)
NVT Power, Video, Datas
Copyright @ Surveillance-video 2018800-955-5201Customer Service
Call or email today to speak with
one of our customer service specialistsTechnical Support
Call or email today to speak with
one of our customer service specialistsTrusted SupplierSECURING THE WORLD FOR 45+ YEARS
Address: 387 Canal St New York, NY 10013
Phone: 1.800.955.5201
Email: info@Surveillance-Video.com
Working Days/Hours:
Mon - Fri: 8:30am - 6:00pm EST
Sat & Sun: Closed
My AccountCompany InformationCloseThank you, we have received your request. A customer
Continue Shopping
support representative will contact you shortly.Sign into Surveillance-video.com
Please enter your email below and we will send you a new password.Create New Account
- General
- Reseller
- Corporate
- Government
- Educational
*Instant Approval
Customer account for end users.
Benefits: Discount Pricing, Order History, Fast Re-order. Instant Approval.*24-48 hour Approval Process
Large volume reseller account.
Benefits: Volume Discount Pricing, Private Sale Fast Re-order.*24-48 hour Approval Process
Large corporations.
Benefits: Discount Pricing, Fast Re-Order, Order History.*24-48 hour Approval Process
Govenment - Government Agencies.
Benefits: GSA Discount Pricing, Fast Re-order, Order History.*24-48 hour Approval Process
Educational Institutions.
Benefits: Discount Pricing, Fast Re-Order, Order History.orOther Social Login
